Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I'm using a Solar Battery tester, does not load test them but verifies the State of health ( 100% ) and state of charge was also 100%,
Charging from Alternator shows around 14 volts - it'a been a Looonnngg time since I ran across a bad starter.
My reasoning is if it's batteries it would not...
Well they both test good with my test meter, charging system passes , alternator charging good as well,
Started 4-5 times then failed to turn over out of the blue, just tries to engage and - no turn.
Now starting to wonder about the starter again.
Thanks , it started off multiple times this morning after charging all nite, Using a tester today to see battery condition / charging circuit etc.
So far passing all the tests.
60K miles on this guy, all of a sudden starter will not turn over, both batteries have good voltage, terminals clean , every thing works except it will not start all of a sudden ,
Looks like I'll need to pull the starter now, Just wondering if anyone else had starter issues with their truck...
If it was the age of the phone it would never work , this stupid thing works and then it doesn't never know when the glitch will show up. It appears there is a problem with U connect and lots of people are experiencing the same problem. I'm trying a factory reset next
I have an I phone 6+ , tried my wife's I phone 7 with new cables , makes no difference , never know if it will work or not, There is no method to the madness, I've reset the phone, reboot each, looked at every setting on both the truck and phone and everything is good, My phone is connected to...
The car play does not come up when I plug in my I phone , sometimes it does bur lately it's very unreliable.
I've swapped cables and tried the wife's phone and still same results.
I've gone into settings and enabled it ( which it was already enabled ) so that was not the issue ,
Not sure if...