Recent content by amoussa1229

Going to be installing some equipment and planning on running wires under the back seat carpet and under the jump seat. Before I start taking things apart, does anyone know if theres clearance to do this? Last time I had it apart it looked like running them would be no issue. Just trying to get...

Trying to piece together here to swap for my 2022 2500. Aside from the list of brackets, screws and panel closeouts from @Musclelogic, are any harnesses required? Big Horn truck getting a Big Horn console, no CD player or rear seat controls. I've seen the infotainment harness, I also saw a...

Just completed the install (haven't programmed yet) and made the harnesses myself. For anyone that needs, here's the wiring pinout for the front driver and passenger doors. Pin 1 on both handles is sense, Pin 2 is return For drivers side, Sense (Pin 1) goes to 4C and Return (Pin 2) goes to 5D...

Thank you. I can program the inputs to be either ground or positive switching so we’re all good there

Looking to buy a full center console for a '22 2500 in black. At least big horn, but no CD player needed. LI, NY if close enough for local. Thanks

Odd question - Going to be installing switches to my '22 2500 gasser. I do not have an Aux PDC currently. These switches are going to be used in conjunction with a Whelen Core, which is a whole vehicle lighting control system. The Core is already installed, and it has spaces for digital...

Haven't seen this asked anywhere yet. Which wire from the door harness goes to which position on the handle harness?

Hello all, In the next week or so, I’ll be removing the front jump seat in my ‘22 CCLB 2500 to replace with an aftermarket center console. I need to retain the original brackets for the jump seat to install the new one. Has anyone removed the seat and is able to shed some light on the best way...

Thanks for the reply. I didn’t see any connectors on either side, but I will check again. I also do not get a Hood Ajar notification on the dash when I pop the hood. As for the remote, I might be interested in doing that. Do you have a link for the write up? Sent from my iPhone using Tapatalk

New to this thread but been looking through most of the posts lol. Just purchased a 2022 2500 Tradesman. I’d like the add remote start and tailgate release. I added a DeeZee tailgate damper just a couple hours ago then found out about 5 minutes after that the factory one snaps right in… I...