What Changes Are Needed In Jscan to Update from 8.4'' non nav to 12'' nav

[Crop Duster]

I'm in the process of upgrading my 8.4'' non nav to the 12'' with nav. I'm using jscan to make the changes and from what I can find on this forum the change in AlfaOBD is cabin Net: ICS Integrated Center Stack to “not enabled". I cannot find that anywhere in jscan. Has anyone used jscan for this upgrade and could possible tell me what I need to change to get it working? Thank you

 

[russ2588]

In Jscan, go to Adaptation tab then go to Module Cabin Network add/remove
Then finally choose ICS-Intergrated Center Stack and deactivate it. This is what i had to do but i went from a 8.4 UC5 with nav to a 12” UC5 with nav.

 

[Crop Duster]

Thank you! I will give that a try.

 

[russ2588]

Thank you! I will give that a try.

on mine that was only needed to get the traction control working. I also had to do a soft reset on mine once installed to get the screen to light up.

 

[Crop Duster]

Ok. I don't have any climate controls working so I'll see where this gets me.