18Bighorn2500
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 1
I have a 2018 Bighorn 2500 that has rear park assist. I am wanting to add the front park assist. So far i have installed the instrument panel with front and rear park assist off buttons. I added the front and rear park module located behind the parking brake. All 3 wire/connectors were there and plugged right in. I add a harness i found on amazon that plugged in behind the driver fender liner. Installed 4 front and 2 side sensors in aftermarket bumper. Used the alph obd and did these steps
VehConfig 1:
PTS Config ->
FRONT & REAR
ECU Config 3: Front park assist present-yes
Cust.Set.Menu 1:
Park Assist CSM Present ->
FEATURE 1 - 2 OPTION
Cust.Set.Menu 1:
Park Assist Brake CSM Present ->
NO
Cust.Set.Menu 1:
Park Assist Front Volume CSM Present ->
YES
And i am having no luck getting them to work. I keep getting parksense service front sensor
Any help is greatly appreciated.
VehConfig 1:
PTS Config ->
FRONT & REAR
ECU Config 3: Front park assist present-yes
Cust.Set.Menu 1:
Park Assist CSM Present ->
FEATURE 1 - 2 OPTION
Cust.Set.Menu 1:
Park Assist Brake CSM Present ->
NO
Cust.Set.Menu 1:
Park Assist Front Volume CSM Present ->
YES
And i am having no luck getting them to work. I keep getting parksense service front sensor
Any help is greatly appreciated.