Recent content by RAM_Dad

I had my truck delivered from MD. I sold my old truck to Carvana for 5k more than MD offered. I told them I didnt want any cleaning done, leave it as it was from the factory. Dealerships suck at washing vehicles. I wasn’t about to have a bunch of swirl marks introduced before I touched it...

You absolutely need a Cummins for that trailer. And if you upgrade to a Cummins, then a 3500 is the logical choice.

I’ve been using the Upside app, not sure if it applies to diesel. Usually get around 5-10 cents per gallon. Not much, but I’ll take it. The biggest savings has actually been at the local grocery chain. They usually have 10-15% cash back in the Upside app. Restaurants usually have good cash...

I agree that the passenger mirror sucks. I’ve driven many different vehicles and none of them use a 1:1 ratio magnification for the passenger side. It’s fine for the drivers side because you’re much closer to it, so you have the appropriate perspective.

A lot of products call themselves “ceramic coatings”. You can get a ceramic spray wax that would last 6 months. I bet that’s what a lot of these places are doing. If I had to guess, it’s a wash, clay bar and spray ceramic wax/sealant. I’d never pay a dealer for any paint work.

Picked up today. Grand Design Transcend Xplor 265BH

Not disagreeing with you

That’s what I meant, #1 foam

Correct, they’re all technically buckets and the “bench” has no impact on seat comfort. There is different foam used in some of the seats though, which may or may not need impact comfort. Ventilated seats have the #10 foam I believe.

@Jimmy07 debunked that in another thread. Seats with ventilation use a different foam material. In a big horn, they’d be the same but not necessarily in higher trim levels.

Good catch, missed that detail.

Correct, AISIN tranny only available with the HO CTD.

Ceramic and PPF. I kid.

What kinda financing rate you get on that? :D

Just curious, what is a 150hp tune even needed for? Doesn’t the truck have plenty of power to handle 15k load at stock?